International Journal of Advances in Scientific Research and Engineering-IJASRE

Stresses Analysis on Spur Gear for Different Contact Ratio

Article Category: Mechanical Engineering

DOI: 10.31695/IJASRE.2019.33424

Pages: 113-119

Author: Khin Khin Thant,Chaw Wint Yee Zaw,Khin Thu Zar

Abstract:

This paper concentrated on the effect of contact ratio on the contact stresses generated on meshing spur gear teeth during the power transmission. In this study, various contact ratios of spur gear teeth have been analyzed. For this contact ratio considered, the rate of loads sharing and angular position of loads were determined on the involute profile of meshing tooth of each gearing. In addition to that, the different stress conditions of this tooth for the critical position (at the instant when the generated contact stress is at the maximum state) are determined. From this study, it is clear that the highest contact ratio resulted in the lowest generated tooth stress (i.e. the highest load-carrying capacity). This approach reduced the contact stresses for power transmission. At last, the results obtained from Hertz’s contact stress formula and AGMA contact stress formula, and then compared allowable stress. They are comparable to each other.

Keyword: Spur Gear, Contact ratio, Tooth profile, Load Sharing, Stresses

This work is licensed under a Creative Commons Attribution 4.0 (International) Licence. (CC BY-NC 4.0)
Copyright © 2018 IJASRE All Rights Reserved

Hit Web Stats