Electrical and Mechanical Properties of Irradiated Polycarbonate Using Argon Ion Beam

Authors

  • M.S. El-Nagdy
  • A.M.Abdel Reheem
  • A.H.Ashour
  • M.I.A. Abdel Maksoud

Keywords:

Argon Ion Beam, Electrical Properties, Mechanical Properties, : Polycarbonate, Stopping Range of Ions in Matter (SRIM).

Abstract

Cold cathode ion source used for irradiate poly carbonate films with different argon ion fluence,0.5 x 1018 and 1 x 1018 ions.cm-2 . Penetration of argon ions are observed and measure using SRIM Program. The values of dielectric constants and dielectric loss
are measure at the frequency range (60 Hz–1MHz).It is also observe that the change in conductivity with influence changes.. The values of the exponent factor for samples are calculated. The mechanical properties including tensile strength (MPa) and elongation at break (%) were tested at room temperature.

Downloads

How to Cite

M.S. El-Nagdy, A.M.Abdel Reheem, A.H.Ashour, & M.I.A. Abdel Maksoud. (2016). Electrical and Mechanical Properties of Irradiated Polycarbonate Using Argon Ion Beam. International Journal of Advances in Scientific Research and Engineering (IJASRE), ISSN:2454-8006, DOI: 10.31695/IJASRE, 2(2), 01–09. Retrieved from https://ijasre.net/index.php/ijasre/article/view/7

Issue

Vol. 2 No. 2 (2016): Volume 2, Issue 2 Feb (2016)

Section

Articles

License

Copyright (c) 2016 M.S. El-Nagdy, A.M.Abdel Reheem, A.H.Ashour, M.I.A. Abdel Maksoud

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.